Controller for Purple Ereada FIR Amethyst Mini Mats with Red Light LEDs

Controller for Purple Ereada FIR Amethyst Mini Mats with Red Light LEDs
Move your mouse over image or click to enlarge
Controller for Purple Ereada FIR Amethyst Mini Mats with Red Light LEDs Controller for Purple Ereada FIR Amethyst Mini Mats with Red Light LEDs Controller for Purple Ereada FIR Amethyst Mini Mats with Red Light LEDs
$ 100.00

CONTROLLER for Purple Ereada Amethyst Photon Mini Mats.

Controller for Purple Ereada Amethyst Mat Mini with Photon Red Light LEDs.

Controllers for Purple Ereada Amethyst Mats Mini have a temperature dial to chose one of seven temperature settings in the range between 86°F~158°F (30°C-70°C) displayed as levels 1-7 on the controller screen.

Controller with Photon function activates Red Light LEDs with 1 hour cycles each 4 hours, auto-shuts off after 2 cycles.

This controller does not have time settings but has built-in safety timer set to automatically turn the mat off in 8 hours.

Heat levels are displayed as Levels on the controller screen.

 LEVEL 1 86°F or 30°C (Sleeping mode)
 LEVEL 2 98°F or 36°C (Low mode)
 LEVEL 3 110°F or 43°C (Low medium mode)
 LEVEL 4 120F or 49C (Medium mode)
 LEVEL 5 133°F or 56°C (Medium High mode)
 LEVEL 6 145°F or 63°C (High mode)
LEVEL 7 158°F or 70°C (Highest mode)

Controller has built-in AUTO EMI ( Electromagnetic waves interception ) function automatically detecting and transferring absorbed EMFs spikes into the wall socket “ground pin” for Earthing.

COMPATIBILITY

THIS CONTROLLER FITS PURPLE EREADA AMETHYST MINI MATS 20"x32".

This controller does not fit Gemstone Magnetic Ereada Mini Mats and Brown Ereada Amethyst Mini Mats. 

Ereada ventilated controller is very durable and if it was not damaged while in shipping process it should work properly for many years.

USEFUL TIPS

To extend life, please, follow these rules:

  • When the controller plug is disconnected from the mat terminal, it is important not to pull the controller plug by the wire as it may damage the connectors or make them loose. The controller cable connector plug is to be pulled by one hand holding the mat connection terminal socket by the other hand and slowly disconnecting each from other.
  • The plug with connector from the controller to the mat terminal socket should be connected tightly. If not errors may be shown. The easiest way to solve any  problems is to reset controller by disconnecting the plug of the controller from the power socket first and then from the mat connection terminal. Then first reconnect the mat tightly and then plug it into electricity socket again. 
  • Do not put the controller on the hot mat. Do not spill water on controller. Never touch it with wet hands. Never wash it or clean with chemicals.
  • If your area is subject to frequent electrical blackouts or power spikes, it could be better to connect the device to electricity through a surge protection, AVR or UPS device similar to that one which protects computers or refrigerators. It will protect the controller from power surge caused faults.

Questions & Answers

Have a Question?

Be the first to ask a question about this.

Ask a Question