CONTROLLER for Brown Ereada Amethyst and Gemstone Mini Mats with N.P.
Q-2000NP Controller for Ereada Mini Mats with Silver Fiber Negative Potential Layer
This controller allows to adjust the temperature of inner low EMF heating systems with 5°C increment in the range 86°F~158°F (30°C-70°C).
It activates and auto shuts-off Negative Potential Electrostatic Field after 30 minutes.
This controller does not have time settings but has built-in safety timer set to automatically turn the mat off in 8 hours.
Heat levels are displayed as Celsius Temperature on the controller screen.
|30°C||86°F (Sleeping mode)|
|35°C||95°F (Lowest mode)|
|40°C||104°F (Low mode)|
|45°C||113°F (Medium Low mode)|
|50°C||122°F (Medium mode)|
|55°C||131°F (Medium High mode)|
|60°C||140°F (Medium High mode)|
|65°C||149°F (High mode)|
|70°C||158°F (Highest mode)|
Controller has built-in AUTO EMI ( Electromagnetic waves interception ) function automatically detecting and transferring absorbed EMFs spikes into the wall socket “ground pin” for Earthing.
THIS CONTROLLER FITS EREADA MINI MATS 20"x32" WITH NEGATIVE POTENTIAL FUNCTION.
IT IS USUALLY USED ON BROWN EREADA AMETHYST MINI MATS AND ON GEMSTONE MINI MATS.
This controller is not compatible with Ereada Mini Mats without Negative Potential function. It can be used only as replacement controller for the Mini Mats equipped with the same model of controller Q-2000NP originally.
Ereada ventilated controller is very durable and if it was not damaged while in shipping process it should work properly for many years.
To extend life, please, follow these rules:
- When the controller plug is disconnected from the mat terminal, it is important not to pull the controller plug by the wire as it may damage the connectors or make them loose. The controller cable connector plug is to be pulled by one hand holding the mat connection terminal socket by the other hand and slowly disconnecting each from other.
- The plug with connector from the controller to the mat terminal socket should be connected tightly. If not errors may be shown. The easiest way to solve any problems is to reset controller by disconnecting the plug of the controller from the power socket first and then from the mat connection terminal. Then first reconnect the mat tightly and then plug it into electricity socket again.
- Do not put the controller on the hot mat. Do not spill water on controller. Never touch it with wet hands. Never wash it or clean with chemicals.
- If your area is subject to frequent electrical blackouts or power spikes, it could be better to connect the device to electricity through a surge protection, AVR or UPS device similar to that one which protects computers or refrigerators. It will protect the controller from power surge caused faults.