Controller for Purple Ereada FIR Amethyst Mats Compact Pro, Pro and Single
CONTROLLER for Purple Ereada Amethyst Magnetic Mats Compact Pro, Professional, Single.
Controller for Compact PRO and larger Purple Ereada Amethyst Mats with Magnetism and Photon Red Light LEDs.
All Controllers for Purple Ereada Amethyst Mats Compact Pro, Professional and Single have a temperature dial to choose one of seven temperature settings in the range between 86°F~158°F (30°C-70°C) displayed as levels 1-7 on the controller screen.
The controller activates magnetism function with 20 min cycles every 2 hours, auto-shuts off after 4 cycles.
Controller with Photon function activates Red Light LEDs with 1-hour cycles each 4 hours, auto-shuts off after 2 cycles.
These controllers have three-time settings for 4, 8, or 12 hours of procedure length to chose. The Timer should be activated to start heating and all other functions. Controller auto-shuts off the mat after preset time expires.
Controllers have built-in air ion function generating negative ions which auto-shuts off after 1 hour of operation.
All functions can be manually activated or stopped at any time by pressing the appropriate button.
Heat levels are displayed as Levels on the controller screen.
|LEVEL 1||86°F or 30°C (Sleeping mode)|
|LEVEL 2||98°F or 36°C (Low mode)|
|LEVEL 3||110°F or 43°C (Low medium mode)|
|LEVEL 4||120F or 49C (Medium mode)|
|LEVEL 5||133°F or 56°C (Medium-High mode)|
|LEVEL 6||145°F or 63°C (High mode)|
|LEVEL 7||158°F or 70°C (Highest mode)|
The controller has built-in AUTO EMI ( Electromagnetic waves interception ) function automatically detecting and transferring absorbed EMFs into the wall socket “ground pin” for Earthing.
THIS CONTROLLER FITS PURPLE EREADA AMETHYST COMPACT PRO MATS 24"x59", PROFESSIONAL MATS 29"x73" AND SINGLE SIZE MATS 39"x75".
This controller does not fit Gemstone Magnetic Ereada Mats and Brown Ereada Amethyst Mats.
Ereada ventilated controller is very durable and it should work properly for many years.
To extend life, please, follow these rules:
- When the controller plug is disconnected from the mat terminal, it is important not to pull the controller plug by the wire as it may damage the connectors or make them loose. The controller cable connector plug is to be pulled by one hand holding the mat connection terminal socket by the other hand and slowly disconnecting each from other.
- The plug with the connector from the controller to the mat terminal socket should be connected tightly. If not errors may be shown. The easiest way to solve any problems is to reset the controller by disconnecting the plug of the controller from the power socket first and then from the mat connection terminal. Then first reconnect the mat tightly and then plug it into the electricity socket again.
- Do not put the controller on the hot mat. Do not spill water on the controller. Never touch it with wet hands. Never wash it or clean with chemicals.
- If your area is subject to frequent electrical blackouts or power spikes, it could be better to connect the device to electricity through surge protection, AVR, or UPS device similar to that one that protects computers or refrigerators. It will protect the controller from the power surge caused faults.
QUESTIONS & ANSWERSAsk a Question
What does each control button do? Photon, Ion and PEMF???
Hello, thank you for your question. These buttons operate mat functions. Please check out the knowledge base link for detailed information Controller for Large Purple Ereada Mats
Can you run all the settings at the same time? (Photon, Ion & PEMF) Or is it best to run individual??
You can run all functions together, or separately one-by-one.