CONTROLLER for Brown Ereada Amethyst and Gemstone Mini Mats without N.P.
This controller allows to adjust the temperature of inner low EMF heating systems with 1°C increment in the range 86°F~158°F (30°C-70°C).
Heat levels are displayed as Celsius Temperature on the controller screen.
30°C
86°F (Sleeping mode)
35°C
95°F (Lowest mode)
40°C
104°F (Low mode)
45°C
113°F (Medium Low mode)
50°C
122°F (Medium mode)
55°C
131°F (Medium High mode)
60°C
140°F (Medium High mode)
65°C
149°F (High mode)
70°C
158°F (Highest mode)
Ereada Mini Mat Controller without N.P. function has either 1 or 8 hours procedure time settings to chose.
The Timer should be activated to start heating and all other functions. It auto-shuts off the mat after preset time expires.
Controller has built-in AUTO EMI ( Electromagnetic waves interception ) function automatically detecting and transferring absorbed EMFs into the wall socket “ground pin” for Earthing.
COMPATIBILITY
THIS CONTROLLER FITS EREADA MINI MATS 20"x32" WITHOUT NEGATIVE POTENTIAL FUNCTION, WITHOUT PHOTON FUNCTION.
IT IS USUALLY USED ON BROWN CLASSIC AMETHYST MINI MATS AND ON GEMSTONE MINI MATS.
This controller is not compatible with Ereada Mini Mats with Negative Potential function. It can not be used as a replacement controller for the Mini Mats equipped with the controller Q-2000NP originally. It cannot be used with Purple Ereada Mini Mats.
But it can be used as a replacement for older white controllers without timer function which were used for Brown Ereada Amethyst Mini Mats prior to 2015.
Ereada ventilated controller is very durable and if it was not damaged while in shipping process it should work properly for many years.
USEFUL TIPS
To extend life, please, follow these rules:
When the controller plug is disconnected from the mat terminal, it is important not to pull the controller plug by the wire as it may damage the connectors or make them loose. The controller cable connector plug is to be pulled by one hand holding the mat connection terminal socket by the other hand and slowly disconnecting each from other.
The plug with connector from the controller to the mat terminal socket should be connected tightly. If not errors may be shown. The easiest way to solve any problems is to reset controller by disconnecting the plug of the controller from the power socket first and then from the mat connection terminal. Then first reconnect the mat tightly and then plug it into electricity socket again.
Do not put the controller on the hot mat. Do not spill water on controller. Never touch it with wet hands. Never wash it or clean with chemicals.
If your area is subject to frequent electrical blackouts or power spikes, it could be better to connect the device to electricity through a surge protection, AVR or UPS device similar to that one which protects computers or refrigerators. It will protect the controller from power surge caused faults.
Is the controller compatible with the Korean far infrared mat's 5 pin A-Connector?
Hello Rolando, Thank you for contacting us. It's difficult to say. Please email us at ereada@ereada.com a picture of your mat, voltage, mat's connector and current controller. After studying, we should be able to make a denifinitive reply and find the appropriate remote for your mat. Sincerely, Andrey